logo

Option rom post error 1716 slot 0 drive array

POST Error: 1716- Slot X Drive Array - Unregenerable Media Errors Detected on Drives during previous Rebuild or Auto- Reliability Monitoring ( ARM) scan. A common option ROM is the video BIOS found on IBM PC compatible video cards. The system BIOS allocates 128 Kbytes of address space for Option ROMs. 00 ( or earlier). Backup and restore recommended. 1803- Slot X Drive Array – Cache Module is not installed Symptom 1803- Slot X Drive Array – Cache Module is not installed.

Fix HPE ProLiant Gen9 Server Auto Reboot. View and Download HP ProLiant Gen9 troubleshooting manual online. Option rom post error 1716 slot 0 drive array. Previous lock up code = 0x13) Action: Install the latest controller firmware. HP assumes you are qualified in the. This document is intended for the person who installs, administers, and troubleshoots servers or server blades.

Re: Attn HP guys, big time bug in Smart Array firmware 4. Option rom post error 1716 slot 0 drive array. The host server has been restarted multiple times since then and it was shutdown gracefully. We have already applied a Diagnostic Test ( with HP SmartStart) and no errors have been detected. You need to make sure you connect the drive to the same port on. 02) and it completely bombed our 1st server; it' s stuck at POST. Option ROM POST Error: 1719- Slot 0 Drive Array – A controller failure event occurred prior to this power- up.

Action Enter a new or valid HPE Smart Array Advanced Pack License Key. Action: Check 1785 Slot 0 Drive Array Not Configured No Drives Detected access the data on the old drives? Some information may notapply to the server you are troubleshooting.
Option ROM Configuration for Arrays. If the problem persists, replace the controller. 52 Post by kubimike » Mon Apr 03, 1: 52 pm 1 person likes this post more info on this now HP is telling me after I had 5 days of open cases that there is another bug in the firmware. The status of a logicaldrive may not be OK. This weekend I powered down our servers to install a new KVM switch. Legacy BIOS Option ROM Allocation Considerations.
49) using identical WD 500 GB drives. Refer to the server documentation for informationon procedures, hardware options, software tools, and operating systems supported by theserver. This utility is designed to enable a logical drive to be configured on a new HP server before the operating system is installed:. I have the array A where I have two disks in RAID1 where you installed the operating system, the array B have four drives in RAID5 where to place the data from users. These constraints are not placed on UEFI Option ROMs, which are commonly referred to as UEFI drivers. I reastarted the server to see what was the problem and i got 2 errors : 1787 & 1716.
IMPORTANT: Unsupported Configuration: Controller performance and supported configurations are limited. The following message appearsAttempting to enable OBDR for Array and Storage Battery are detected. How do BIOS extensions ( option ROMs) work? I have set up RAID1 using the " RAID Option ROM" utility ( version 3.

Failed Drive Stuck HP Smart Array P410. HP replaced the FBWC daughtercard for the P222 and the problem was resolved. Action: No action required. Re: DL310e Gen8, iLO 4 reports 1783- Slot X Drive Array Controller Failure, but everything seems fine The problem ended up being a faulty flash backed write cache card. Errors will be fixed automatically when these sectors are overwritten.

Fixed automatically when the sector( s) are overwritten. When I powered this server back up, I' m getting errors indicating the Smart Array has lost its configuration information ( specifically 1785 - Slot 2 Drive Array not configured) It does not detect any logical drives and obviously will not boot. ProLiant Gen9 Server pdf manual download. Problems with DL380 Gen9 Smart Array.

As a guest, you can browse. Internal PXE option ROM is used for booting from the NIC to a PXE server. Before installing an operating system, you can use the ORCA utility to create the first logical drive, assign RAID levels, and establish online spare configurations. Previous Rebuild or Background Surface Analysis ( ARM) scan. Official HP site for genuine HP parts and Compaq parts. Cause A license key is missing or has expired.

HP post errors POST Error: 1716- Slot X Drive Array - Unrecoverable Media Errors Detected on Drives during. I then get a warning in yellow saying there. ( Previous lock up code = 0x13) This issue will occur with any ProLiant Gen9 server and a compatible Smart Array Controller or Smart Host Bus Adapter ( HBA) with Firmware Version 3.

I opened the iLO2 through the web console and found the status IML message " POST Error: 1792- Drive Array Reports Valid Data Found in Array Accelerator" Posted on 3/ 24/. Diagnostics show the physical drives. FIRMWARE UPGRADE RECOMMENDED for Specific SAS Hard Drives to Prevent 1716- Slot x Drive Array - Unrecoverable Media Errors Message During Power- On Self- Test on HP Smart Array Controllers Using Zero Memory RAID.

As before, HP System Management reports that everything is OK with the arrays and power. Sounds like either your array controller or disks may be at fault. I have tried ctrl slot= 0 array A remove drives= 1I: 0: 3.

1719- Slot 0 Drive Array - A controller failure event occurred prior to this power- up. It says the same thing during post that the Array controller needs configuring. Option ROM Configuration for Arrays 9 Option ROM Configuration for Arrays About ORCA ORCA is a ROM- resident array configuration utility that executes automatically during initialization of an HP Smart Array controller.

Com is WARNING: WARNING 0002: POST Error: 1770- Slot X Drive Array. We already connected to the ILO searching errors and we' ve seen " HP Proliant - Post Error: 1792 Drive Array Reports Valid Data found in Arary Accelerator" into IML Log. 1 ConstructTests. Audible Beeps: None Possible Cause: The array accelerator configuration has been updated automatically due to replacement of the array accelerator ( or controller) with one having different cache memory size.
Page 146 ORCA Option ROM Configuration for Arrays operating system POST Power- On Self Test processor power module ProLiant Support Pack RBSU ROM- Based Setup Utility RILOE Remote Insight Lights- Out Edition RILOE II Remote Insight Lights- Out Edition II reserve information sector read- only memory serial attached SCSI SATA serial ATA Systems. I’ ve had this before, try powering the server off and reseating the drives, that might get the server to work quickly for the time being. This is a special case of an option ROM, as it is loaded very early on in the boot process so that output from the power- on self- test ( POST) can be displayed.
Welcome to BleepingComputer, a free community where people like yourself come together to discuss and learn how to use their computers. I understand that an installed device may have it' s own BIOS that adds features to the system but I' m not sure of how they are set up. ( Previous lock up code = 0x12). " attached all the event messages. 1716- Slot z Drive Array Controller - Unrecoverable Media Errors Detected on Drives.

HP ProLiant Servers Troubleshooting Guide Abstract This document describes common procedures and solutions for the many levels of troubleshooting for HP ProLiant G7 and earlier servers. Nscldaq- cvscommits] clients/ DeviceSupport/ caenv1x90 AcqModeTests. 1726- Slot X Drive Array - Cache Memory Size or Battery Presence Has Changed. " Only option setup host from beginning again Still waiting see what HP says. Replace the drive failed to upload. Option rom post error 1716 slot 0 drive array.
The utility also provides support for the following functions: Reconfiguring one or more logical drives; Viewing the current logical drive. Array Accelerator configuration has automatically been updated. I keep reading the following address range 0x0C0000 to 0x0F0000 is used but I don' t understand what this is used for.
In Legacy BIOS boot mode, PC architecture constraints are placed on Legacy Option ROM allocation. Search through thousands of replacement parts for HP printers, and HP and Compaq computers. The following message is logged in HP Proliant Server iLO IML. I have no idea if this is related to the amber light on the disk. HP ProLiant Servers - FIRMWARE UPGRADE RECOMMENDED for Specific SAS Hard Drives to Prevent " 1716- Slot [ x] Drive Array - Unrecoverable Media Errors" Message During Power- On Self- Test on HP Smart Array Controllers Using Zero Memory RAID. On a Compaq/ HP server, ( I think I’ m right in saying) the array configuration information is stored on the disks and the array.

It is a local HDD running in RAID. Reseat the controller in the PCI slot. However, now I don' t seem to be able to find the option to reconstruct the RAID in the RAID Option ROM utility.

Action: Reseat the array accelerator module. After one of the drives failed, I have installed a matching replacement. NOTE: This guide provides information for multiple models of servers. Using the site is easy and fun. The second solution, I opened the Array Configuration Utility and checked my arrays. Even though we have not seen any failures, we began testing the firmware update ( 3.

Problem will be fixed automatically when the sector( s) are overwritten. 32 Critical POST Message 04/ 25/ 09: 40 04/ 25/ 09: 40 1 Option ROM POST Error: 1719- Slot 0 Drive Array - A controller failure event occurred prior to this power- up. 1778- Drive Array Resuming Automatic Data Recovery Process. Severity= Caution date= [ NOT SET] time= description= Option ROM POST Error: 1792- Slot 3 Drive Array - Valid Data Found in Write- Back Cache. If this message is displayed after Options ROMPaq is run, problems may have occurred while attempting to flash the ROM. Option rom post error 1716 slot 0 drive array. In Computer Setup, set Advanced > Device Options > NIC PXE Option ROM Download to DISABLE to prevent PXE option ROM for the internal NIC from being downloaded during POST to free more memory for an expansion card' s option ROM. 0 MB Punting this back to the queue.

Data will automatically be written to drive array. We had the Linux guys perform the upgrade on there server and although it appears to have applied successfully, the firmware version never changed to 3. The seventh edition of the HP ProLiant Servers Troubleshooting Guide, part numberxx7, incl uded the following additions and updates: • Added new information about Server updates with an HP Trusted Platform Module and BitLocker™. Tks POST Error: 1716- Slot X Drive Array - Unregenerable Media Errors Detected on Drives.